Quadrocopter – the begining26/06/2012 | Filed under: Uncategorized
Ok, I have not blogged about this project before but I have been working on it for almost two years now on and off, the router project took a lot of time so I have not been able to work on this as I wanted. Since my router project is now “finished” or at least is up and running I have spent the last month working on my newest Quadrocopter. Before I make post on my newest progress I want to show you my first designs and toughts.
First of all I started to order all the parts I needed. I ordered alot of parts to have enough of spares in case something would brake. I bought the controller board from Aeroquad wich is a open source project. Other parts I bought there were the propellers. Other parts I bought from Hobbyking, I did buy a lot of wires, connectors, heat shrink tubes, carbon fiber plates and tubes and other parts I tought would come handy in the build. My initial tought was to make the Quad as light as possible. Below is my first design.
My first flight was not succsessfull to say the least, it went up trough two rolls and crash landed with the frame broken, all props broken and one motor damaged. This was quite frustrating but I started to make another frame. The frame was made from balsa wood and carbon fiber tubes glued together and was extremely light. The next flights were more successfull and I managed to fly but my pilot skills
were really bad. I added 1kg of steel bars on the quad to make it slower and more controlable. This helped alot and surprised me how much weight it was able to carry.
Here are few pictures of it almost ready to fly.
After a few flights my frame had sufferd a lot of beating and I had to make a new one. At this point I wanted to make proper frame so I decided to finish my router build.
It took me a while to finish the router build but now I have “finished” the router and also made the first frame with it. More pictures and videos from the build and the first flights coming soon.